Products › How-to
How-to
Subcutaneous injection
A one-minute animated tutorial showing, step by step, how to reconstitute a peptide and give a hygienic subcutaneous injection.
The video narration is in French; the steps are written in English below.
The 4 steps
- Reconstitute the peptideDisinfect the stopper of both vials. Draw up the bacteriostatic water, inject it slowly down the inside wall of the vial, then swirl gently, without shaking, until the solution is clear.
- Disinfect the siteDisinfect the skin about 5 cm (2 in) from the navel with an alcohol swab, then let it dry for a few seconds.
- Draw up the doseDisinfect the stopper again, turn the vial upside down and draw up the intended dose with a new insulin syringe. Tap the syringe to remove air bubbles.
- InjectGently pinch the skin, insert the needle at 45° to 90°, inject slowly, wait a few seconds, then withdraw the needle. Dispose of the syringe in a sharps container.
Supplies
- Peptide vial
- Bacteriostatic water (see the reconstitution section)
- New insulin syringe
- Alcohol swabs
- Sharps container
Key points
- Use a new syringe for every injection.
- Alternate sides of the navel from one injection to the next.
- Keep the reconstituted vial in the refrigerator.
- When in doubt, consult a healthcare professional.
For educational purposes only. This video illustrates a general subcutaneous injection technique; it gives no dose and does not replace advice from a healthcare professional.
← Back to products
OH